RESET RESET or SS RESET with caps and not. There are different wireups in there, e.g. The RESET button is an input connected to nothing else (if you don’t press the button) so nothing bad should happen.Įdit: Also, the page should be the main source of information for the wireup. You can check whether it makes a difference if you connect the the SS pin of the Mega to the bottem left pin of the reset button (in regards to the above posted picture) (or touch it while programming with a male-male cable). Am I blind or does the bottom right pin of the ISP header, which is supposed to be RESET, go nowhere, just between the two headers themselves, but not to the actual RESET pin of the chip, which is just connected to one pin of the button? Hardware error? The SPI SlaveSelect (SS) line must definitely go the RESET of the target. The picture is cutoff at the left so I can’t see if you have a capacitor installed between RST and VCC, further the breadboard at the bottom is cut off.Ī thing I find weird in the target board is the RESET line. The terminal process “C:\Users\HP Gaming atformio\penv\Scripts\pio.exe ‘run’, ‘–target’, ‘upload’” terminated with exit code: 1. Reading | # | 100% 0.02sĪvrdude: Yikes! Invalid device signature.ĭouble check connections and try again, or use -F to override pio\build\ATmega644\firmware.hexĪvrdude: AVR device initialized and ready to accept instructions pio\build\ATmega644\firmware.elfĪdvanced Memory Usage is available via “PlatformIO Home > Project Inspect” LDF Modes: Finder ~ chain, Compatibility ~ softĬhecking size. HARDWARE: ATMEGA644 8MHz, 4KB RAM, 63KB FlashĭEBUG: Current (simavr) On-board (simavr)
now we have an Invalid device Signature ErrorĮxecuting task in folder BlinkyTest: C:\Users\HP Gaming atformio\penv\Scripts\pio.exe run -target upload Sanguino ATmega644 or ATmega644A (8 MHz) I’m afraid I do have a space in the username.Īdding the quotation marks worked.
0 kommentar(er)
